Atlas Copco Air Compressor S67 Air End 1303032080

BOAO stands as a professional provider entirely dedicated to supplying genuine Atlas Copco air compressor parts. 

Their unwavering commitment to authenticity means every 1303032080 S67 Air End you acquire from them is a product manufactured to Atlas Copco's exact engineering specifications and undergoes rigorous factory quality control. Purchasing from BOAO helps eliminate the inherent risks associated with non-genuine air ends.

 These risks include imprecise rotor profiles, inferior bearing quality, or improper balancing, which can lead to rapid wear, catastrophic failure, and substantial downtime. 

Therefore, partnering with BOAO provides unwavering confidence in the quality, reliability, and long-term performance of this crucial compressor component.

General Installation Steps (Requires Specialized Expertise & Tools):

1. Critical Safety Protocols: Crucially, ensure the compressor is fully de-energized, isolated from all power sources, and properly locked out/tagged out according to established safety procedures. Relieve all internal pressure from the system and allow components to cool completely. Drain all compressor oil into an appropriate container.
2. Disassemble Surrounding Components: Carefully remove all connecting pipes, hoses, electrical wiring, and structural components that impede access to the air end. This often includes removing the motor, oil separator tank, coolers, and control panel. Document every step, taking numerous photographs and labeling all connections for accurate reassembly.
3. Support and Remove Old Air End: Use appropriate lifting equipment and slings to safely support the weight of the air end. Disconnect all remaining mounting bolts and carefully remove the old 1303032080 S67 air end from the compressor frame. Exercise extreme caution during removal to prevent injury or damage.
4. Inspect Frame and Connections: Thoroughly clean and inspect the compressor frame, motor coupling, and all connecting interfaces for any damage, wear, or debris. Address any issues before proceeding with the new air end installation.
5. Prepare New Air End: Unpack the new, Genuine Atlas Copco S67 Air End 1303032080. Ensure all protective caps are removed and inspect the air end for any transit damage. Apply a thin film of clean compressor oil to the rotor tips, bearing surfaces, and seals as required by the manual to aid in smooth startup.
6. Install New Air End: Carefully lower the new air end into position on the compressor frame using lifting equipment. Align it precisely with the motor coupling and mounting points. Secure all mounting bolts to the specified torque values, following a strict crisscross tightening sequence.
7. Align and Connect: Reconnect the motor to the air end, ensuring precise coupling alignment. Reconnect all oil lines, air inlet/outlet piping, and sensor wiring. Replace all gaskets, O-rings, and seals with new, genuine parts during reassembly to ensure leak-free operation.
8. Lubrication and Pre-Checks: Refill the compressor with the correct type and quantity of genuine Atlas Copco compressor oil. Perform a thorough pre-start inspection, manually rotating the air end (if possible and safe) to ensure smooth, unhindered movement.
9. Commissioning and Testing: Restore power to the compressor. Perform a controlled initial startup and commissioning procedure as per the manufacturer's manual. Monitor all operational parameters (pressure, temperature, vibration, noise) meticulously during initial operation. Conduct a thorough leak test on all connections.